Hi Mukesh,
From Business perspective i am with you that we will have a scenario where we receive the material and store in SLoc(A) and system should allow to transfer the stock from SLoc(A) to SLoc(B). I was looking for the alternate solution and found that there is a T-Code in SAP QAC2 which allows you to transfer the stock from SLoc A to SLoc B when Inspection lot are active and automatically transfer all the relevant quant from SLoc A to SLoc B
So in my opinion you can perform the process in two step
1) Transfer the stock from SLoc(A) to SLoc(B) using QAC2 while inspection lot are still active
2) Perform QA decision using QA11
Quant before QAC2 (Stock in SLoc PR01)
Image may be NSFW.
Clik here to view.
QAC2 (Change of SLoc from PR01 to WM01)
Image may be NSFW.
Clik here to view.
System automatically creates and confirm the transfer order based on the customization for Movement type (In this case it picks Inventory MvT 323 and WM MvT 309)
Quant information after QAC2
Image may be NSFW.
Clik here to view.
The only con of this step is Inspection lot should be active and it is possible within the same stock category
as i mentioned earlier i am not much familiar with QM module however in last couple of days based on your query i have gone through few standard SAP document to understand QM module so thanks to you for helping me to increase my Knowledge base. As far as above solution are concern please get in touch with your QM consultant to re validate
Let me know if this helps
